These are the steps:
1. Start out by installing the Debian Wheezy image on an SD card and boot the RPi with it.
2. When raspi-config starts, run through whichever items you need to configure. In the following steps, you should be root.
3. Type the following commands:
apt-get update
apt-get upgrade
4. Get rpi-update from https://github.com/Hexxeh/rpi-update and install it. There are good instructions there, but to save time and starting up LXDE to access the site, you can type:
wget http://goo.gl/1BOfJ -O /usr/bin/rpi-update && chmod +x /usr/bin/rpi-update
5. Before you run rpi-update, you’ll need git, so type:
apt-get install git-core
Then, run rpi-update by simply typing:
rpi-update
6. Plug in your usb audio adapter. Mine is the SYBA SD-CM-UAUD USB Stereo Audio Adapter and I plugged it into a powered hub. ALSA sees this as a C-Media USB Audio Device.
7. When you type “cat /proc/asound/cards”, you should see that the adapter is card 1. Typing “cat /proc/asound/modules” should show that the driver for card 0 is snd_bcm2835 and the driver for card 1 is snd_usb_audio. This means that ALSA is currently configured to send audio to RPi’s built-in audio output hardware. The RPi doesn’t have built-in audio input hardware, so ALSA won’t have a Capture device configured.
8. This step configures ALSA to use the usb audio adapter as the default device for audio input and output. The most elegant way to do this would be to configure ALSA to switch between the adapter and built-in hardware depending on whether the adapter was plugged in. If you need that feature (I dont’t), you should check out the instructions at http://superuser.com/questions/172514/alsa-usb-audio-hotplug. So, in /etc/modprobe.d/alsa-base.conf, you should see the following couple of lines at the end of the file:
# Keep snd-usb-audio from being loaded as first soundcard
options snd-usb-audio index=-2
On the options line, I changed index=-2 to index=0.
9. To reload alsa-base.conf, type
alsa force-reload
10. Now, /proc/asound/cards will show the adapter as the default (card 0). If you plug a headset into the adapter, you should be able to record audio from the mic (e.g. “arecord -d 5 -r 48000 test.wav” will make a 5 second recording) and play it back through the headset speakers (e.g. aplay test.wav). Use alsamixer to adjust the Speaker output level and the Capture input level (if you don’t see the Capture control, press F5) to get the best results.
11. Now, on to pocketsphinx. Download the latest versions (0.7, at this writing) of sphinxbase and pocketsphinx from http://cmusphinx.sourceforge.net/wiki/download.
12. Extract the downloaded files (sphinxbase-0.7.tar.gz and pocketsphinx-0.7.tar.gz) into separate directories.
13. To compile these packages, you’ll need to install bison and you’ll need ALSA development headers. NOTE: It is important that the ALSA headers be installed before you build sphinxbase. Otherwise, sphinxbase will not use ALSA. It also appears that ALSA will not be used if PulseAudio is installed (thanks to NickE for discovering this). So, type:
apt-get install bison
apt-get install libasound2-dev